There are many problems of using wearable breast pump from some new users. Below to show some normal questions and answers for your reference.
1. Question: Does the silicone inside the cup need to be replaced after being used for a long time? How long is it?
Answer: All milk contact materials, we recommend timely cleaning, disinfection after each use. Our milk pump used materials are high - grade food materials. The silicone part is recommended to be replaced once a month.
2. Question: Do you put the cups in as a whole or disassemble them and boil them separately? What's the highest temperature?
Answer: We are not sure whether other breast pumps in the market can do it. As for our breast pumps, the milk cup, tee and other plastics can withstand the high temperature of 160°, and all the silicone temperature range is between 200-300°. There is no problem with high temperature boiling disinfection.
3. Question: After the cup is partially cleaned and disinfected and assembled, how can I judge whether it is properly installed?
Answer: Plug the horn, observe whether the counter current valve with the work of the air pump shrinkage change, if have change that is installed ok.
4. Question: In the process of sucking milk, can milk water go against the current if it is too much?
Answer: Our products are completely anti - current. In the process of sucking milk, pay attention to remove milk in time to prevent milk overflow.
5. Question: After sucking milk into the bottle is very slow, tilt too big is easy to spread outside, tilt how much is the most appropriate?
Answer: The milk has a certain consistency, and there is no need to tilt when pouring milk, because our elastic wall design, only need to gently press the thumb slightly, the pressure of the cup body changes, the milk will flow out automatically.
6. Question: Is the bigger the suction of the breast pump, the better?
Answer: The stronger the suction, the stronger the strength of the knowledge representative to pull on the nipple, but cause damage to the nipple, causing pain resulting in poor experience of mommy. A good breast pump should be able to easily squeeze the breast to stimulate the milk matrix, soothing and uniform baby simulation breast pumping.
7. Question: Why are many breast pumps on the market being complained of leakage of milk?
Answer: 1. The silicone and the gas cup are not installed closely, so it is necessary to make sure that the trumpet silicone is tightly matched with the cup body.
2. The bell mouth is too small, and the breast Size of European and American women during lactation is larger. The bell mouth of the milk pump in the market is generally about 100 degrees, which cannot be wrapped, and it is easy to slip in the process of use.
3. The scale mark is not obvious, the maximum actual capacity is not defined, and the milk cup is not marked with MAX, so the user does not know how much can be filled, and keeps sucking milk, and eventually overflow.
4. The speed of sucking milk is greater than the speed of leakage of the duck's mouth valve, resulting in the milk can not be timely into the milk cup, resulting in milk overflow. Requires a precise grasp of silicone hardness and pressure.
8. Question: Can the host machine be cleaned with water?
Answer: Please strictly follow the instructions, the host is not waterproof, do not put the host with other accessories into boiling water disinfection.
9. Question: What is the function of the memory function of the breast pump?
Answer: At present, all our breast pumps are equipped with memory function, which is more convenient for users to experience.
10. Question: Is there any order of massage/breast pumping/correction?
Answer: Massage: Before breast pumping, it is recommended to massage for 3 to 5 minutes, which can relax the body and mind, stimulate hormones and stimulate the milk matrix, and the effect of breast pumping is better
Breast pumping: 9 gears, according to the personal feelings of the treasure mother to choose when the corresponding gear, it is recommended to gradually adjust from low to high, do not choose the maximum gear at the beginning
Correction: Adopt three short and one long design, suitable for novice Bao Ma and Bao Ma with sunken nipples.
