usage
Electronic thermometer function diagram
Electronic thermometer function diagram
1. Before using the thermometer, the head of the thermometer should be disinfected with alcohol.
2. Press the switch, the buzzer will beep immediately, the display is shown in Figure A, and the time is about 2 seconds.
3. Then the display shows the temperature of the last side measurement as shown in Figure B (assuming the last measurement was 36.5°C), and it lasts for about 2 seconds. Then the display may display as shown in Figure C. The "℃" symbol flashes, indicating that the thermometer is in the standby state. (At this time, if the room temperature is higher than 32°C, the thermometer will display the room temperature instead of the display shown in Figure D, and the "°C" symbol will continue to flash)
4. Use the thermometer to measure your body temperature. The temperature value displayed when the body temperature is measured gradually rises, and the "℃" symbol keeps flashing at the same time.
5. When the body temperature rise rate is less than 0, 1℃ within 16 seconds, the "℃" symbol stops flashing, and the thermometer beeps for about 5 seconds. At this time, the thermometer is measured and the displayed body temperature can be read.
6. The clinical thermometer has an automatic shutdown function and will automatically shut down within 10 minutes after the end of the measurement. However, in order to extend the battery life, it is recommended that the user press the power button to turn off the power after the measurement is over.
Way
Correct measurement method of electronic clinical thermometer
When measuring body temperature, the temperature will deviate due to the influence of the temperature measurement time, outside air, and different body parts. In order to obtain accurate temperature measurement data, please always keep a certain temperature measurement position. When under the armpit, the electronic thermometer should be close to the temperature-sensing part; when under the tongue, the electronic thermometer should be inserted tightly at the base of the tongue.
Precautions
Precautions for electronic thermometer
1. When the rear position of the electronic thermometer displays "□", it means that the battery needs to be replaced. The battery adopts AG3 button battery or SR41 silver oxide battery. When replacing the battery, first remove the upper battery cover. Squeeze down the switch guide skin and pull out the movement about 2.5mm (the movement cannot exceed 3.5mm), and use a small bottle screwdriver to remove the battery. Insert a new battery with the positive side facing up, insert the movement, and close the battery cover carefully.
2. The electronic thermometer can be cleaned by wiping with a damp cloth, if it is waterproof, it can be directly placed in water for cleaning. Do not place it in high pressure gas, high temperature environment, and do not contact with corrosive materials. The damage caused by this is not responsible for the quality guarantee:
3. Working temperature: 10°C-40°C Working humidity: 30%-80%RH
4. Storage temperature: -1°C-60°C Storage humidity: 10%-80%RH
5. Service life: AG3 or SR41 button battery is about 200 hours
6. Display accuracy: ±0.1°C (from 32°C to 43°C) or ±0.2°F
